NefMoto

General => General Discussion => Topic started by: madswp on November 08, 2012, 02:37:20 PM



Title: John Deere Remapping information
Post by: madswp on November 08, 2012, 02:37:20 PM
goodevening everybody

anybody know a good forum or website which contains information about remapping agricultural products /  tractors?
also which flashing tool is recommended to read/flash these ECU's
i am daily working as a John Deere mechanic and need to do a little research about these engine controllers. but find it very hard to find any information about these.

cheers ;)


Title: Re: John Deere Remapping information
Post by: aef on November 09, 2012, 03:36:33 AM
Try DigitalKaos


Title: Re: John Deere Remapping information
Post by: madswp on November 09, 2012, 11:13:47 AM
Try DigitalKaos

thank you very much aef.. that is a kickass forum with lots of nice info 

but still not much about remapping.. only changing hours and disable vmax mainly. 



Title: Re: John Deere Remapping information
Post by: icezero on November 30, 2012, 02:28:55 AM
good tool to read and write is a byteshooter the remap is really simple as with all trucks  8)


Title: Re: John Deere Remapping information
Post by: madswp on November 30, 2012, 10:17:00 AM
yeah everything is easy when you know how to do it  ;) how do these controllers work? a little like remapping the EDC15-16-17?  does there exist any dokumentation like the FR? cant find anything anywhere to start from. always the beginning that is worst.
i know byteshooter should be able to read them. but what about the new R series of john deere with delphi level 21 ECU's?



Title: Re: John Deere Remapping information
Post by: icezero on December 03, 2012, 03:00:12 AM
i search the next days a damos for you ;-)


Title: Re: John Deere Remapping information
Post by: madswp on December 03, 2012, 01:01:27 PM
that sounds great  ;D  we do a some flashing through my work, but uses the 'my genius' by dimsport. think its the slave tool course cant get anythin usefull by the Bins it is reading. so have to invest in my own tool and thinking byteshooter. but needs to read the new controllers too. do you have any experience with this?

we have a LOT of different tractors which i can read en original BINs from, and have unlimited acces to a 600kw dyno to check the engine performances afterwards.