|
Title: SWNumber Mismatch Error! Post by: btsbarton on December 18, 2012, 10:04:20 PM Hi! Im new to this program, just trying to get it set up. First of all, I want to give a huge thank you to the developers of this software, and for distributing it for free!
Ok, so Ive got a 2001 Audi Allroad 2.7T, Tiptronic, ECU# 4Z7907551K, Dahlback chip soldered onto the ecu So I downloaded all the software, got the files all ready, got the cable plugged in and connected to the car(verified, because I pulled codes in VagCom), then when I click run, I get this error: Code: -> Read ECU ID's .... done I initially had a similar error, but it was a HWNumber mismatch. I was dumb and downloaded the K-box ecu file with 8D0(S4) instead of 4Z7(allroad) prefix, luckily I figured that out LOL. So I downloaded the right ECU file, and tried again, but now Im getting a SWNumber mismatch, and I dont know where to look for that. Any help would be greatly appreciated! Title: Re: SWNumber Mismatch Error! Post by: nyet on December 18, 2012, 11:08:22 PM Whatever image is in your ECU does not have the same SWNumber as the image you used with ME7L
Title: Re: SWNumber Mismatch Error! Post by: btsbarton on December 18, 2012, 11:10:21 PM Does this mean I need to create a custom image of my ECU?
Title: Re: SWNumber Mismatch Error! Post by: btsbarton on December 21, 2012, 09:19:29 PM Figured it out, now trying to figure out why I get limp mode at 6100rpm. Uploading this to post on Audizine.
Title: Re: SWNumber Mismatch Error! Post by: nyet on December 31, 2012, 10:57:41 AM Any codes? Perhaps MAF signal too high?
Might have to increase KFMLDMX and/or MLMAX |