|
Title: Trying to Flash new Revised tune. Having problems Post by: awdlaunch on January 21, 2013, 09:35:36 AM Hey Guys,
I'm trying to flash a revision, it connects fine, but won't write. I had ended up just canceling it after about 25 min. Here is what it all said. Any ideas? Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init succeeded. Switching to KWP1281 session. KWP1281 connect info: 2.7tt /5VT G 0002 Connecting to address 0x01. Slow init succeeded. Switching to KWP2000 session. Connected Disconnecting... Disconnected Switching to KWP2000 session. Validated FTDI device is in dumb mode. Disconnected Connecting... Starting fast init connection. Connecting to address 0x01. Fast init sent, sending start communication request. Switching to KWP2000 session. Connected Disabling Windows sleep mode. Writing ECU flash memory. ECU reports programming session preconditions have been met. Negotiating communication timings. Successfully changed to new communication timings. Requesting security access. ECU reports that security access is not supported. Starting diagnostic session. Successfully started diagnostic session. Negotiating communication timings. Cancelling current operation. Writing ECU flash memory failed. 100% complete. Restoring Windows sleep mode. Disconnecting because there was no successful communication within 5000ms. Disconnected Title: Re: Trying to Flash new Revised tune. Having problems Post by: phila_dot on January 21, 2013, 11:04:02 AM What baud rate are you using?
Title: Re: Trying to Flash new Revised tune. Having problems Post by: awdlaunch on January 21, 2013, 11:40:55 AM 124800. I tried one lower, but now it won't even connect. I have restarted my computer and unplugged and plugged in my cable and now all I'm getting is this:
Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Failed to setup FTDI device. Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init failed. Disconnected |