|
Title: can not connect Post by: Socalk61000 on April 07, 2013, 11:43:50 PM ok so ive been trying and trying to get my cable to connect and it wont do it it just keeps saying
Failed to read test echo from FTDI device. Could not open FTDI device. I think I re did the drivers right and when i hover over the ross tech usb device it says premium features supported but it wont do anything please help Title: Re: can not connect Post by: hello on July 16, 2013, 07:24:36 PM Are your drivers installed correctly?
Title: Re: can not connect Post by: aysix on August 10, 2013, 11:47:36 AM Which cable? What OS are you using?
Title: Re: can not connect Post by: ddillenger on August 10, 2013, 11:56:12 AM You need to deselect "Boot in intelligent mode" in the VCDS settings.
Also, it doesn't hurt to install the VCP (virtual com-port) drivers as well, as they're needed for argdubs tool, and many others. Title: Re: can not connect Post by: nattyS4 on August 21, 2013, 06:02:38 AM Did u ever figure out what the issue was? im having the same error but i'm using a dumb cable so not really sure, I think its a driver issue.
Title: Re: can not connect Post by: hello on August 27, 2013, 06:38:42 AM Did u ever figure out what the issue was? im having the same error but i'm using a dumb cable so not really sure, I think its a driver issue. Try to uninstall the drivers. http://www.ftdichip.com/FTDrivers.htm Get the latest and then try again. Let us know. Title: Re: can not connect Post by: adam- on August 28, 2013, 07:05:08 AM Use the newest drivers from the FTDI site - I use the Virtual ones, seem to work first time, every time. Using a cheap eBay copy.
Make sure your port number is right in device manager, if not, change it between 1 and 4. I like it set at 3. If you switch USB ports, the port number sometimes changes, so try and always use the same port! |