|
Title: 95040 write fail Post by: Drehkraft on April 08, 2013, 08:24:59 PM Anyone have issues writing the 95040 with a burner? I have a stubborn chip that will not fully write.
It fails at 00040, skips 4 bytes and continues writing until 00090, skips for bytes and carries on until further down the file (does it again several times!) I've even gone as far as desolder the chip and put it in my burner. I'm thinking a bad eeprom at this point. Anyone in Canada have any to spare? I don't really want to wait for cross border shipping. Title: Re: 95040 write fail Post by: ddillenger on April 08, 2013, 08:27:19 PM Anyone in Canada have any to spare? I don't really want to wait for cross border shipping. I'm not in Canada, but I have a few dead ecu's I can pull one off of and throw in an envelope, Just let me know if you want one! Free of charge of course. Title: Re: 95040 write fail Post by: k0mpresd on April 08, 2013, 08:38:23 PM i have flashed a LOT of 95040 chips (obd and burner) and never had one that wouldnt fully write.
i would check your programmer several times just to make 100% sure all is ok. Title: Re: 95040 write fail Post by: Drehkraft on April 08, 2013, 09:06:17 PM I have flashed quite a few of these before with the same setup, and never an issue.
ddillenger - if I can't find anything local I'll msg you. Thanks! Title: Re: 95040 write fail Post by: k0mpresd on April 08, 2013, 09:20:32 PM what programmer?
Title: Re: 95040 write fail Post by: Drehkraft on April 09, 2013, 06:51:15 PM GQ 4X.
|