|
Title: file size error Post by: Inzunzar on May 08, 2013, 02:34:36 PM I am trying to flash a new file on my ECU for an audi S4, the original file was 512kb and the new one is of 1Mb but when flashing the file shows me an error saying "invalid file size: 'name.bin' <error=0x01>"
Do you know something about this? any configuration change required to flash a different size file? or maybe a blank flash to the EEPROM? Thanks Title: Re: file size error Post by: jimmcgee5 on May 08, 2013, 02:44:22 PM :-\ you are trying to fit a 1024k file onto a 512k chip , see if you look at those two numbers a bit , you will see how it wont work ;)
Title: Re: file size error Post by: Inzunzar on May 08, 2013, 02:52:50 PM So do I need to change the EEPROM or what?
Title: Re: file size error Post by: nyet on May 08, 2013, 02:57:55 PM Get an ECU with a 1M flash.
Title: Re: file size error Post by: phila_dot on May 08, 2013, 03:01:30 PM What tool are you using?
What ECU is it? What file? It sounds like you're using ArgDub's tool and attempting to write to the wrong chip. Title: Re: file size error Post by: Inzunzar on May 08, 2013, 03:12:54 PM ECU is 8D0907551Q, file is from Jfonz, I am using ME7 95040
Title: Re: file size error Post by: nyet on May 08, 2013, 03:17:09 PM ECU is 8D0907551Q, file is from Jfonz, I am using ME7 95040 ME7_95040 is an eeprom programmer, not a flasher. Title: Re: file size error Post by: Inzunzar on May 08, 2013, 03:47:48 PM thanks, I will use NefMoto, I am new to this and learning
|