|
Title: Map sensore 0mBar . on audi TT 8n help Post by: invasione on June 13, 2013, 12:30:16 PM hi ..
before I had the sensor that marked 1400mbar to the max .. even though I had 1.6bar (2600mbar was to mark) while taking measurements of volts coming to the map sensor I have sent to earth or something positive that from that moment I felt making a disconnect! type fuse near the camshaft position sensor .. since they sharato the 5v with the blue wire and brown I thought something is missing .. I tried 2 and 3 ECU map but I can not come out the sensor is 105 http://sphotos-h.ak.fbcdn.net/hphoto...81584255669de6 I tried to bring 3 wires from the pin of the ECU to the sensor but nothing .. I checked the voltage there something not quite right because the purple wire gray if I connect it I 0 bar with p0237 error on vag while if I unplug the highest bar with error p0238. I changed 3 map therefore exclude their problem and 2 different control units (although I have the maximum values of 2 mbar different from the ECU is mapped to a cause I believe) Audi TT 8N 1999 AJQ with motor APX .. desperate, I turned to this service also .. but unfortunately you read the outcome .. http://www.justanswer.com/audi/7t1dw-audi-tt-8n-error-map-g31-g71-f96.html Title: Re: Map sensore 0mBar . on audi TT 8n help Post by: invasione on June 15, 2013, 03:27:34 AM hi .. before I had the sensor that marked 1400mbar to the max .. even though I had 1.6bar (2600mbar was to mark) while taking measurements of volts coming to the map sensor I have sent to earth or something positive that from that moment I felt making a disconnect! type fuse near the camshaft position sensor .. since they sharato the 5v with the blue wire and brown I thought something is missing .. I tried 2 and 3 ECU map but I can not come out the sensor is 105 http://sphotos-h.ak.fbcdn.net/hphoto...81584255669de6 I tried to bring 3 wires from the pin of the ECU to the sensor but nothing .. I checked the voltage there something not quite right because the purple wire gray if I connect it I 0 bar with p0237 error on vag while if I unplug the highest bar with error p0238. I changed 3 map therefore exclude their problem and 2 different control units (although I have the maximum values of 2 mbar different from the ECU is mapped to a cause I believe) Audi TT 8N 1999 AJQ with motor APX .. desperate, I turned to this service also .. but unfortunately you read the outcome .. http://www.justanswer.com/audi/7t1dw-audi-tt-8n-error-map-g31-g71-f96.html help :( Title: Re: Map sensore 0mBar . on audi TT 8n help Post by: invasione on June 16, 2013, 10:05:29 AM I recreated the sensor with the resistance to ground and I 140Kohm marks 1060mbar .. because with 3 sensors wrong?
|