|
Title: boot mode with ST10 Post by: lulu2003 on August 11, 2013, 09:15:09 AM Hi,
are there bigger differences to read ME7 1 MB flash 29f800 with ST10 processor instead of normale old c167 in Boot mode? I am not sure if I make an error by setting boot pin(s) or if my tool (MPPS) has problems with it? Currently cannot cross check with C167. If yes, which tools instead of byte shooter , CMD etc. can do that? Title: Re: boot mode with ST10 Post by: ddillenger on August 11, 2013, 10:57:24 AM That's the CAN-bus ME7.1.1 correct? If so, big differences getting into bootmode.
Title: Re: boot mode with ST10 Post by: lulu2003 on August 11, 2013, 02:00:35 PM I think I have a software problem:
meanwhile I can get it into boot mode, at least I managed to read 1MB external flash and there is an option to read the st10 flash. but writing my 1MB file into the external flash does not work after erasing the flash... Title: Re: boot mode with ST10 Post by: vwaudiguy on May 28, 2015, 10:41:51 PM Did you ever figure out your issue, lulu?
|