|
Title: rover mems 3 Post by: rehtnap on September 16, 2013, 05:36:51 AM hi
im trying to read a rover 45 mems 3 obd enabled ecu with a galletto 1260. i have 2 cables one a chinese clone and one a cheap vag kkl. im using the 1260 proper english software from this site with the ftd drivers as well and both cables have the correct id number in the chip to match the software. im attempting to read via the obd port(ecu still in car). with galletto clone cable when it reads the ecu data it comes back as zeros then when it attempts to save ecu data it fails after 3 mins or so with a sk1 seed errore with the kkl cable it does the same but the seed errore is sk5 is there a list of what the sk errores relate to. galletto says it should read this ecu has anyone had any success reading one or point me in the correct direction. |