|
Title: Reading PIN from RS6 ECU using ME7_95040 Post by: alrightroad on September 26, 2013, 06:14:03 PM Good evening. I have a bench setup, tested successful PIN reads on several C5 allroad and C5 A6 ECU's and printed them to screen no problem. Saved a few bin files, etc. I also used several different cables just to see if they would work with ME7_95040 and yep. Now, when I hook up RS6 ECU's I cannot read either one of them (7.1.1). Received error=0x01. Nothing to do with com port, cable, computer, power supply, etc.
Run positive lead to pin 26 on ECU harness with resistor? I ran positive to 26 without resistor and still error. Ground the socalled boot pin? I'm stuck but will keep trying. Thanks, in advance. Title: Re: Reading PIN from RS6 ECU using ME7_95040 Post by: Captainiglo on November 12, 2013, 12:34:03 PM Hi,
I've got the same problem, but also can't get it into boot mode. I received error=0x07. Is it the type of ECU or something? Title: Re: Reading PIN from RS6 ECU using ME7_95040 Post by: Milka on November 12, 2013, 05:03:54 PM Try using a resistor, I have no issues with getting these ECUs into boot mode with a resistor
Title: Re: Reading PIN from RS6 ECU using ME7_95040 Post by: Captainiglo on November 13, 2013, 01:51:59 PM I successfully got in to bootmode with the Galletto, but didn't try with the ME7_95040.
I will check next time. |