NefMoto

ok so did a oem save of a 8D0907551A box "epl stage 2 / flashing to a base file stage 3", file saved as a 512k file "should be 1024k correct?

ive tried to flash a few files, every one erases writes correctly "it says"

if i get ecu info with vagcom i get ecu # as -THIS - IS- THE - WSC 00000"

any ideas anyone? ive played around with baud, never had an issue on this setup with any other ecu's

thanks eprom is a 29F800BB

ecu was believed to have a epl street tune i was erasing and saved for backup to restore...

"2000 b5 s4 ecu a box"

It´s Boot Time !!!  ;D

You have an corrupted file... flash ori file in bootmode

thanks for the reply, from what ive read  i'm in fail safe mode, i've been in boot mode the whole time flashing, i tried flashing a OEM same box code file but nothing.... same results, i was just trying to go from a box epl stage 2? to m box stage 3 base "tony" to edit a fresh start..... all i did was read this box one time and it dumped a 512k file, i could care less about the epl tune just want a working ecu or a stage 3 base!!!

by ori do you mean oem a box file? thanks for the help!!! :D

You should have 1mb files, not 512k.

Also, don't confuse boot mode and bench flashing, it's not the same thing.

yes exactly my point, ive flashed a few ecu's many times over and over in the past, always using gellatto, always on the bench in boot mode...

  the very first time i read this ecu it dumped a 512k file.. if i read it always gets the "THIS-IS-THE-RAM-PROGRAM" for info

 the only reason i read it was for backup for this ecu... ive tried to flash it over and over and it always says 100% complete and comes out corrupt in fail safe mode.... can a new blank eprom be bought of ebay and be soldered on? or are there any repair tools/software?

thanks guys

29F800BB-70SE is factory, I use 70-SD as they're easier to get.

If you want to send it my way I can fix it.

thanks as always ddillenger.... so i should be able to solder in the blank eprom and itll flash with standard gelletto and not a stand alone eprom burner?

if i sent to you you would just solder in a new chip or try a software fix? i was just trying to help a friend with a base file for the cost of shipping, not sure if this ecu was damaged before it was sent to me, all i did was read and dump for backup and it instantly dumped a 512k bin the first time "in boot mode at that" i knew something was up when the bin was not 1024k.... 

are you local usa or over seas?

Are you sure you have the right memory layout selected in Galletto? 29F400BB=512kb 29F800BB=1024kb

I'd try a software repair first, then hardware.

yes, ill double check, but ive flashed my ecu's numerous times with out any issues ever.. would the epl tune corrupt the eprom "security"
 just in a data read? like i said im not sure what the previous owners have done to this ecu...

ddillenger you're the man! rookie mistake, the whole time i over looked the 400 vs 800 eprom settings :) much much appreciated the time everyone took to reply!