|
Title: Launch Control Post by: gigabyte on October 09, 2013, 04:33:21 PM Hey there
I have adjusted the maps for launch control to be implemented in my tune. Before I try it and burn down the road like the bat mobile just want to check some questions in my head. 1- Launch control is always active till you drive faster then the VNMX setting? 2- ITNMXH is for 2 step? 3- TNMXH this only comes into effect if you use launch control? So you will never have to worry about throttle shutting off if you dont use the launch control? 4- Is a decat required or is that just for hard lanch control? My settings are VNMX 1.25 kmh DNMAXH 50 rpm ITNMXH 0 NMAX 3500 rpm NMAXOG 7000 rpm TMOTNMX left at 80.25c TNMXH 655.3500 Sorry if this is answered before just need to make sure I fully understand it. Cheers Title: Re: Launch Control Post by: krazydbiker on October 10, 2013, 06:00:48 AM just check your nmaxog, its DNMAXH + NMAXOG so your at 7050 rpm for a rev limit.
other then that, looks fine, TNMOTNMX will keep you stuck at a 3500 RPM limit till you exceed that temp, i recommend changing it. as far as cats, cats do not like popping/unburnt fuel........ you will get a little bit but its not like anti-lag where it will blow your cats right out. Title: Re: Launch Control Post by: gigabyte on October 10, 2013, 06:14:35 AM Cheers I kept TMOTNMX as it was didn't want to use it unless engine is warm but I'll take your advice and change it mate. Yeah I heard anti-lag is a killer for cats. I give it a try later have to find a quiet spot somewhere ;D
Cheers again mate |