|
Title: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: oldcarguy85 on October 22, 2013, 06:20:29 AM I'm following the wiki steps for rear O2 removal (i think pulled from phila_dot's findings). I found 2 of the codewords that were not in the XDF i'm using (which is a very complete xdf for 06a906032DR). the rest, i'm not sure if they apply to 1.8t or not? I'm using the HN map pack as a reference and just looking for patters/values that match up. Could you possibly verify the 2 i found and maybe give me some guidance on the rest?
Found: CWDLSAHK - 0x186F7 val: 9 (i think this should be changed to 0) CWKONLS - 0x181BB val: 3 (i think this should be changed to 1 for 1.8t) Can't find (don't have any reference map pack for 1.8t that has these): CDLSHV, CLRHK, CLRKA Title: Re: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: oldcarguy85 on October 26, 2013, 02:51:19 PM ok so i made some progress--- i think.... if anyone could possible verify this i'd greatly appreciate it. I haven't actually tested any of these yet.
CDLSHV - 181AC - set to 0 CLRHK doesn't exist i think? I think its instead CLRSHK on this ecu? i may be totally wrong on thta. Value was 16. I will change to odd value of 0. THis could be totally wrong, idk. CLRKA also doesn't exist. i guess it's because this is a wideband car? instead, its CLRSKA at 19E5B -- set to 0 from 1 Title: Re: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: ddillenger on October 26, 2013, 03:01:37 PM CLRSHK=17.
What are you doing with CDLSHV? Title: Re: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: oldcarguy85 on October 27, 2013, 07:33:14 PM CLRSHK=17. What are you doing with CDLSHV? I think I actually did set CLRSHK to 17 (typo in my last reply) but I'll double check. As for CDLSHV, I set it to 0 per the recommendations of the wiki. Is that not correct? Thanks again for all the help on this! Title: Re: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: ddillenger on October 27, 2013, 08:53:10 PM I think I actually did set CLRSHK to 17 (typo in my last reply) but I'll double check. As for CDLSHV, I set it to 0 per the recommendations of the wiki. Is that not correct? Thanks again for all the help on this! CDLSHV=Lambda sensor interchange recognition. You have a 4 cylinder, only 1 lambda sensor, so there is no 2nd lambda to interchange, thus no use for CDLSHV. Title: Re: Help finding a few code words (and verifying a couple) - 06A906032DL Post by: oldcarguy85 on October 27, 2013, 09:20:35 PM Makes perfect sense. Thanks again!!
|