|
Title: Throrrle doesnt open past 50 % Post by: 20VTMK1 on November 23, 2013, 01:08:04 PM Hi All ,
Need some advice please, Airflow is good , boost is where it should be - HP is right for the airflow however , the throttle plate wont go past 50 % . Pedal is at 100 %. Could it be a mistake in PDKSD ? The ori PDKSD had all values greater than 0.95 (reference to VDKUG) and in the higher ratio and rpm areas of the map , more than 1.2 I changed PDKSD to the same as PDKSE as PDKSD structure follows the same as most of the 1.8 bins I have seen , could this have been the issue ? CWPLGU is set to 0 in the stock bin. Gonna go physically check that the throttle goes to 100 % as well as check the adaption . Any ideas ? Title: Re: Throrrle doesnt open past 50 % Post by: littco on November 23, 2013, 10:25:37 PM Hi All , Need some advice please, Airflow is good , boost is where it should be - HP is right for the airflow however , the throttle plate wont go past 50 % . Pedal is at 100 %. Could it be a mistake in PDKSD ? The ori PDKSD had all values greater than 0.95 (reference to VDKUG) and in the higher ratio and rpm areas of the map , more than 1.2 I changed PDKSD to the same as PDKSE as PDKSD structure follows the same as most of the 1.8 bins I have seen , could this have been the issue ? CWPLGU is set to 0 in the stock bin. Gonna go physically check that the throttle goes to 100 % as well as check the adaption . Any ideas ? Are you trying to accommodate for a stronger actuator? Title: Re: Throrrle doesnt open past 50 % Post by: TCSTigersClaw on November 25, 2013, 01:57:33 AM did you find a solution ?
Title: Re: Throrrle doesnt open past 50 % Post by: 20VTMK1 on November 29, 2013, 09:23:20 AM Hi guys ,
Sorry , was away for a while ... It turned out to be the PDKSD , reverted back to stock and all was well . Now tho , the throttle linearity is a bit off . I think I need to change the axis as per new WG and see how it goes. I am sure it had to do with the fact that all the values were more than VDKUG in stock form . Littco , yes a new WG in place . |