|
Title: cluster pin code request Post by: mat350z1 on December 16, 2013, 09:46:49 PM hello every one.
so im working on this 2000 jetta that needs a new cluster, i managed to get a used cluster from junkyard, but when i plugged it in, and ran the car it only ran for a second and shut off, so i proceeded to defeat the immobilizer form the ecu, after doing so the car ran fine, however after a few seconds of running the instrument cluster would shut down the the back lighting would go out and the needles would drop. im guessing this is because the cluster thinks the car is not running so it shuts itself off.??? what Ive done so far is read both the eeproms, original and new(used) cluster. i did this because i know that it is possible to do a cluster adaptation using vcds if you have both pin codes. my issue is that i cannot figure out what the pin code is from looking at the bin files. i know that the pin is listed three times in the data but im not sure exactly what it could be. does anyone have an idea of what the pin codes are, of the two files i have attached. Title: Re: cluster pin code request Post by: k0mpresd on December 16, 2013, 09:59:17 PM new: 1787
old: 6000 |