NefMoto

Technical => Flashing and Chipping => Topic started by: Topspeedwolf on March 10, 2014, 02:22:33 PM



Title: Read Chipped 8N0 906 018 BH
Post by: Topspeedwolf on March 10, 2014, 02:22:33 PM
I have a Chipped ECU on my table, I opened it, and this is what I see. It does not look normal.

Can I Read/Write it normal with NefMoto Software and Galletto 1260
without problems in Boot Mode ?


Sorry for my bad english  :-\


Title: Re: Read Chipped 8N0 906 018 BH
Post by: ddillenger on March 10, 2014, 02:28:44 PM
Looks like MTM. You cannot flash over it, but you can read it.


Title: Re: Read Chipped 8N0 906 018 BH
Post by: Topspeedwolf on March 10, 2014, 02:49:56 PM
So it's only intended that the dealer can't overwrite it?

I can use the normal Boot Mode Pins ?



Title: Re: Read Chipped 8N0 906 018 BH
Post by: ddillenger on March 10, 2014, 03:10:25 PM
You cannot overwrite it, even in bootmode! It has an encryption board! You must replace it with a stock chip. If you are in the US I can do that for you.


Title: Re: Read Chipped 8N0 906 018 BH
Post by: Topspeedwolf on March 10, 2014, 03:22:24 PM
Yes I understood, thank-you ! I want to read it first and Save, and then replace it with a Stock Chip, I'm from Europe but thanks for the offer.