|
Title: CamshaftAngle wnwi_w Post by: bk56190 on April 28, 2014, 11:29:38 PM Hello,
It's a non VVT cam tensioner (new), cam position sensor is new. I wonder why camshaftangle doesn't stay near 0°. After 4500tr/min, angle rises, so VE decrease and torque decrease... Title: Re: CamshaftAngle wnwi_w Post by: ddillenger on April 28, 2014, 11:40:16 PM A couple degrees is normal. It wouldn't look so bad if the scale were bigger.
Title: Re: CamshaftAngle wnwi_w Post by: bk56190 on April 29, 2014, 12:17:13 AM The scale is bigger, but when I look logs from other members, it doesn't rise after 4500tr/min.
Do you have WOT logs with wnwi_w ? Title: Re: CamshaftAngle wnwi_w Post by: MIL_on on April 29, 2014, 02:01:11 AM 2 degrees can happen. I also dont think that this lowers your torque by 30%.
Title: Re: CamshaftAngle wnwi_w Post by: bk56190 on April 29, 2014, 04:41:37 AM Ok thank you, first I was thinking about a bad chain.
Title: Re: CamshaftAngle wnwi_w Post by: Snow Trooper on April 29, 2014, 08:07:43 AM Normal
Title: Re: CamshaftAngle wnwi_w Post by: bk56190 on April 29, 2014, 01:53:36 PM Ok :)
Title: Re: CamshaftAngle wnwi_w Post by: bk56190 on July 23, 2014, 12:35:40 PM Hi,
I cheked dwnwsp_w (difference between camshaft and cranckshaft) and the value is -9°. I believe it's not normal ? I can't check with vagcom with blocks 091-092-093, all are blank. |