|
Title: Carprog TT Cluster Repair Post by: jase1979 on September 07, 2014, 07:47:50 AM I've already listed a problem with my tt cluster showing 999999km and I need to correct it. I now have carprog and there is a way by soldering a few wires to reflash the MCU, has anyone done this before? Do you now what it does to the eeprom info like the immob data and skc?
From what I understand, the MCU holds the eeprom data and the software for the cluster? The cluster is a Jaeger, Magenti Marrieli type and believer it has a motorolla MCU. Thanks for any replies, find information on this is proving to be very difficult. Title: Re: Carprog TT Cluster Repair Post by: k0mpresd on September 07, 2014, 09:05:24 AM these are easier points to solder than the ones carprog shows directly on the mcu.
picture is of a beetle, same for tt. Title: Re: Carprog TT Cluster Repair Post by: jase1979 on September 07, 2014, 11:39:36 AM Thanks for the picture k0mpresd, that does look easier. Do you know what happens the the immob and odo if I reflash using carprog?
Does the odo change to 0? and do I have to adapt the cluster back to the ecu? Thanks again Title: Re: Carprog TT Cluster Repair Post by: k0mpresd on September 08, 2014, 07:31:10 AM carprog only reads and writes the mcu and 24j. you will need to do all the editing yourself.
|