|
Title: Is it possible to write 24c02.bin on board via clip... Post by: Mo Arif on September 08, 2014, 01:13:04 PM ...on a Bosch Me 3.8.3 ECU, i've researched a bit and getting mixed answers, some say no you can't it will fry, has to be de-soldered yet others say you can if you give a particular pin a 12v or Ground? please can someone confirm this.
:) Title: Re: Is it possible to write 24c02.bin on board via clip... Post by: Mo Arif on September 15, 2014, 07:08:40 AM Anyone? I'm able to de-solder the chip and replace it; but i heard it's possible to so without removing the chip.
Title: Re: Is it possible to write 24c02.bin on board via clip... Post by: ddillenger on September 15, 2014, 07:12:39 AM I tried powering the ecu, then writing in circuit. It failed both times I attempted it.
Now I just remove the eeprom. Title: Re: Is it possible to write 24c02.bin on board via clip... Post by: f1torrents on September 15, 2014, 07:36:23 AM I have also had no sucess doing it on the board.
Just remove. I even tried shorting the crystal oscillator, but I did nothing. Title: Re: Is it possible to write 24c02.bin on board via clip... Post by: eliotroyano on October 07, 2014, 05:33:13 AM According to some VAG documents is should be possible to read it through OBD port.
|