|
Title: MPPS not reading full 1mb flash Post by: dave926 on October 12, 2014, 01:42:32 PM Back story:
Bought an ECU from eBay. Finally got all the stuff for a bench setup. Tried Galletto but couldn't connect so I hooked up my MPPS. Read the full 1mb file no problem. Put the ecu in boot mode (I think) and flashed a basic stage 1 file but not under ' Generic '. Tried to read out the file and match it with Winols to ensure success but the only thing coming out is around 320kb. What am I missing? Title: Re: MPPS not reading full 1mb flash Post by: ddillenger on October 12, 2014, 06:22:06 PM Is the file NOREAD? Is MPPS real or clone?
Title: Re: MPPS not reading full 1mb flash Post by: MIL_on on October 13, 2014, 12:37:40 AM flash it again in Bootmode using the generic Setup and then read back via obd to test it
btw. which ECU is it? Title: Re: MPPS not reading full 1mb flash Post by: dave926 on October 13, 2014, 03:33:06 AM Clone of course. Maybe some day I will buy a real MPPS if this ever turns into something besides just screwing around.
The ecu is 06a906032hs 00008, I flashed an hs 00007 to it. I realized the reason why I couldnt get Galletto to work is because the ecu does not see the drivers for it. I changed the cable correctly too with Mprog. Title: Re: MPPS not reading full 1mb flash Post by: TCSTigersClaw on October 13, 2014, 06:26:51 AM You flashed in boot ,but not under Generic ? what did you choose to flash it ?
Just flash it again in boot mode as MIL_ON said with your ORI file . Then start over. Original MPPS is a must ,it is not screwing around :) Title: Re: MPPS not reading full 1mb flash Post by: dave926 on October 13, 2014, 07:55:33 AM When I tried under Generic it went about 20% and stopped. Not sure if it's a clone issue or it not being in boot mode.
Title: Re: MPPS not reading full 1mb flash Post by: dave926 on October 13, 2014, 09:23:56 AM Somewhat separate issue, but I changed the EPT on my blue cable and now it will not connect. Windows says the driver cannot be found
I have attached the ept that is currently on my cable. Title: Re: MPPS not reading full 1mb flash Post by: dave926 on October 17, 2014, 08:12:33 PM Update:
I powered up the ecu using normal pins and pin 121. Got bootmode with MPPS without issue after. The file I was using before was based on an .bin output from Winols, started from this file http://nefariousmotorsports.com/forum/index.php?topic=4171.15 (http://nefariousmotorsports.com/forum/index.php?topic=4171.15). I think its corrupt as it only flashes a 330kb file but shows 1mb (can someone verify?) Re-flashed the original file the ecu came with, and re read a 1mb file off it. Flashed an SL file to it, and re read a 1mb file off it after. Currently waiting for a new blue cable to arrive....... |