NefMoto

car: Audi A3 1.8T quattro 150hp -00.
ME 7.5(?)
06A906032AC

Thought id try to read this ecu, and ive validated the 29f800BB memory layout = ok.
started the flash read, and everything seems to work fine up till ~57%, flash checksums = ok.

but, from 58% and onwards, it keeps saying flash checksums do not match, retrying.. 3 attempts, and then skipping and continue to read.
what happens here? does this affect the bin-file produced.. or does it still match the contents of my ecu-flash?
the whole procedure took ~47 minutes..

ill attach the produced bin-file, if someone with more knowledge would be so kind to have a look at it..  :-\

@ sn00k :

Thanks for posting this file. I was looking for it.

You chose to use the 1mb flashconfig but the flashrom itselfe is a 512kb one ! :)

Therefore the act-up i presume.

A simple hex-editor correction does the job. Readout is 100%.

Corrected file added

Cheers,

PvL

I think that ECU is ME7.1 - 512kb so just use 400BB layout.

file is definitely ME 7.5.

as youve noticed it is a 512kb file, i figured this out months back, but i never got around to correct the file and upload it here, so thanks pvl for doing that =)

i have better cables, tools etc for reading ecus nowadays, i remember reading this file took like FOREVER..  ;D

If its 512kb then its narrowband.

yes, it is very much narrow band, as alot of other ME 7.5 ecus, in fact ALL pre -01 are narrowband in europe.
5.9s in early 1.8ts and then 7.5 in the later 99 and 00 ones.