|
Title: ZKLAMFAW in 018CM? - 2002 Passat Post by: SB_GLI on November 05, 2014, 09:33:18 AM I'm having lamfa issues... filtering just like we had in the a4 1.8t community project. I can't seem to locate zklamfaw, or whatever it is in this ecu. It's not before lamfa like in the a4 file.
See the attached screen shot. Notice that the linear decline of AFR Desired. I want this to reach my target AFR quickly, vs the slow linear decline that it's doing now. Any help? Title: Re: ZKLAMFAW in 018CM? - 2002 Passat Post by: Jerry Tunin on June 05, 2015, 07:13:09 AM I'm having lamfa issues... filtering just like we had in the a4 1.8t community project. I can't seem to locate zklamfaw, or whatever it is in this ecu. It's not before lamfa like in the a4 file. See the attached screen shot. Notice that the linear decline of AFR Desired. I want this to reach my target AFR quickly, vs the slow linear decline that it's doing now. Any help? Where you able to figure this out? Title: Re: ZKLAMFAW in 018CM? - 2002 Passat Post by: MadCow on June 05, 2015, 01:39:29 PM I asked the same question in the CH box definition thread, no response so far. From what I know ZKLAMFAW is a variable rather than a map like in the B6, so it'll probably need disassembly to find it.
Title: Re: ZKLAMFAW in 018CM? - 2002 Passat Post by: SB_GLI on June 08, 2015, 08:55:16 AM I asked the same question in the CH box definition thread, no response so far. From what I know ZKLAMFAW is a variable rather than a map like in the B6, so it'll probably need disassembly to find it. I ended up just switching to the CH file, where this was not an issue. Since then, I'm using BTS fueling anyway. :) |