|
Title: Me7.1 95040 help!! Please Post by: Waspjr on November 15, 2014, 09:49:57 PM Ok so I have a working cable i confirmed this on my b6 a4 its a 232r ftdi i have the latest drivers via the ftdi site. Now I have k line at 43, 12v at 62, ground on 1 and tried 2 and 12v on 3. Thats ecu side now obd side is 4&5 gnd tried just 5 as well Kline is 7, 16 is 12v i tried grounding pin 24 before power on for 5&10 sec. Also ground 24 power on ignition power off then on held ground for 5 sec then removed then ignition off. And i still can't get nef or 95040 to connect. Am i correct in using not kwp2000 but boot mode on the nef menu.
Please help i am at a stand still trying to get this ecu to work for my 2.7 swap Thanks Title: Re: Me7.1 95040 help!! Please Post by: turboat on November 16, 2014, 03:16:12 AM Bootmode in nef doesn't work, use argdub's tool to read the EEPROM.
Title: Re: Me7.1 95040 help!! Please Post by: Waspjr on November 16, 2014, 03:30:02 AM Bootmode in nef doesn't work, use argdub's tool to read the EEPROM. Ok good to know i was mainly using it to check if i had the ecu in boot mode and I was using argdubbs tools the whole time. Is it just me or are some me7.1's stuborneTitle: Re: Me7.1 95040 help!! Please Post by: Waspjr on November 22, 2014, 01:38:21 AM Well still no joy i had a old me3.8 and i managed to link it and connect to nef. So either i have screwed my me7.1 or it was dead before.
Title: Re: Me7.1 95040 help!! Please Post by: turboat on November 22, 2014, 02:13:21 AM Can you connect to it in obd mode with Vcds, or anything really? First check that the bench cable is working properly, then worry about boot mode.
Title: Re: Me7.1 95040 help!! Please Post by: Waspjr on November 22, 2014, 10:30:34 AM No I cannot connect with vcds nef or argdubbs tool.
The me3.8 i could connect via nef but it would let me do anything aparently a unreadable EEPROM from my readings. And vcds would connect or argdubbs |