|
Title: M Box issues - NefMoto won't connect and it won't go into boot mode Post by: GWerks on June 25, 2011, 02:55:07 PM Hey guys,
A couple weeks ago I tried helping my buddy out, he has a 04 A6 2.7T that somehow stopped running after he was ''messing'' around with NefMoto, his car would not start, long story short, I ended up bringing my spare ECU to his house to see if we could get the car to run with my M-Box since his car had a Hitachi MAF sensor, after removing the small guide from the bigger connector on the ECU off I put my M box in his car and flashed it with Galletto, we still didn't get his car running. Anyway, yesterday I tried putting that ECU in my car and it won't start, NefMoto will NOT connect to it and I can't even put it into boot mode with Galletto. Any ideas of what else I could try? Title: Re: M Box issues - NefMoto won't connect and it won't go into boot mode Post by: littleredwagen on August 09, 2011, 06:35:24 AM Hey guys, A couple weeks ago I tried helping my buddy out, he has a 04 A6 2.7T that somehow stopped running after he was ''messing'' around with NefMoto, his car would not start, long story short, I ended up bringing my spare ECU to his house to see if we could get the car to run with my M-Box since his car had a Hitachi MAF sensor, after removing the small guide from the bigger connector on the ECU off I put my M box in his car and flashed it with Galletto, we still didn't get his car running. Anyway, yesterday I tried putting that ECU in my car and it won't start, NefMoto will NOT connect to it and I can't even put it into boot mode with Galletto. Any ideas of what else I could try? 04 A6 2.7t uses 7.5 with immobilizer. most likely you might have fired your m-box by plugging it in Title: Re: M Box issues - NefMoto won't connect and it won't go into boot mode Post by: infinkc on August 09, 2011, 08:35:51 AM So you tried another m box again and the same result, hmm. I sent you an email.
Title: Re: M Box issues - NefMoto won't connect and it won't go into boot mode Post by: judeisnotobscure on August 09, 2011, 10:24:57 AM I think it was only one mbox... the a6 had the proper ecu in it. Then they tried to run it on the mbox... then the mbox was put back in an s4 where it belongs.
|