|
Title: What eeprom 06A 906 032 RE (solved) Post by: nobug on December 23, 2014, 07:02:31 PM Trying to immo off a ME7.1.1 ecu VW part# 06A 906 032 RE
If I use the me7gui and use options for 95160 Pin 6.3 I get a bin file, but some code just doesn't look right. I manually did immo off but no luck, Vag Com will only communicate with it once when plugged into the car and then I get no communication errors. When it does communicate I get fault codes for eeprom errors. Anyone now the eeprom this ecu uses? Cheers Title: Re: What eeprom 06A 906 032 RE Post by: ddillenger on December 23, 2014, 07:06:08 PM Trying to immo off a ME7.1.1 ecu VW part# 06A 906 032 RE If I use the me7gui and use options for 95160 Pin 6.3 I get a bin file, but some code just doesn't look right. I manually did immo off but no luck, Vag Com will only communicate with it once when plugged into the car and then I get no communication errors. When it does communicate I get fault codes for eeprom errors. Anyone now the eeprom this ecu uses? Cheers Whats the eeprom say? Try 5P08C3. Title: Re: What eeprom 06A 906 032 RE Post by: nobug on December 23, 2014, 07:18:33 PM Whats the eeprom say? Try 5P08C3. OK thanks, will check it out tomorrow, first chance I get. I tried to read the numbers on the eeprom but they are hardly visible even with a magnifying glass, I didn't see any numbers that looked familiar to me. It probably is 5P08C3 Title: Re: What eeprom 06A 906 032 RE (solved) Post by: nobug on December 24, 2014, 01:59:09 PM Solved
ECU had a 95160 eeprom, I had another ECU with the same part# so I opened it to read the # on the eeprom. The problem was removing the resistor totally screwed with the reads and writes to the eeprom and I was not able to communicate with the ecu thru vcds. Put a jumper back on it where the resistor was then I was able to read and write to the eeprom, vcds works like it should and everything is fine. |