NefMoto

Hello all

I just done repair my FIS cluster,im adding another tread about those cluster on the community :)

At first i bought a Maxidot LCD from Europe, but we failed to solder it the right way, so we just bought another one, but the new chinese version because it was cheap , 40$. The Maxidot was removed but the tiny connector got damaged

The fading LCD:
(http://s25.postimg.org/mpshi4iaj/FIS2.jpg) (http://postimg.org/image/mpshi4iaj/)
(http://s25.postimg.org/mpshi4iaj/FIS2.jpg) (http://postimg.org/image/mpshi4iaj/)

Once soldered
(http://s25.postimg.org/43equg7mj/20141220_193542.jpg) (http://postimg.org/image/43equg7mj/)

testing on the Bench
(http://s25.postimg.org/cfahvp50b/20141220_193619.jpg) (http://postimg.org/image/cfahvp50b/)

My complete bench setup, with my PC power supply, it came from a old 386 server

(http://s25.postimg.org/44oonv9gb/20141220_193630.jpg) (http://postimg.org/image/44oonv9gb/)

Close-up, the new series has the controler on a board-- I also cut the metal lip where usually this press on the ribbon cable, i cut it to give less pressure on the ribbon (the maxidot was full widht)
(http://s25.postimg.org/utgflxrx7/20141220_195220.jpg) (http://postimg.org/image/utgflxrx7/)

Another immo2 cluster testing -- Notice that i removed the buzzer on both cluster.. the annoying buzzer, but on the top one i left the empty housing

(http://s25.postimg.org/ip5rip4ez/20141220_200124.jpg) (http://postimg.org/image/ip5rip4ez/)

(http://s25.postimg.org/xme8jphnf/20141220_200228.jpg) (http://postimg.org/image/xme8jphnf/)

Testing with needles and all
(http://s25.postimg.org/y341jvusb/20141220_201535.jpg) (http://postimg.org/image/y341jvusb/)

closeup on my bench wiring - i do my ECU mapping that way too

(http://s25.postimg.org/e7824cdqz/20141220_205318.jpg) (http://postimg.org/image/e7824cdqz/)

(http://s25.postimg.org/puxil5di3/20141220_205349.jpg) (http://postimg.org/image/puxil5di3/)

End result:
(http://s25.postimg.org/x2gm9p7kr/20141222_084838.jpg) (http://postimg.org/image/x2gm9p7kr/)