|
Title: Big Troubles after trying to get the ECU into Bootmode PLEASE HELP Post by: R32VAG on May 04, 2015, 07:17:25 AM Hello,
now i have a big trouble, yesterday i try to read out my ME7.1.1G from a Golf V R32 in boot mode. This was not possible. I try it some times. So i put the ecu back into the car. Now the car wont run normaly. Sometimes the car need a long time to start the engine. Then the engine runs at 100rpm. When i pull the gas down the rpm goes up and the machine runs normaly at 700rpm. Then i can drive normaly! The Fan is also running permanently. I read out the ecu with VCDS. There shown some failures.: Internal Control Module - Memory Check Sum Error Enginge Coolant Temp. Sensor (G62) Implausible Signal Air Intake Temperatur Sensor Implausible Signal When i go to the Measuring Blocks: Air Intake Temperatur is still -16 Celcius Coolant Temperature is still -1.0 Celcius Whats the Problem?? May i bricket the eprom flash chip? Sorry for my bad english, i hope you can unterstand it. Title: Re: Big Troubles after trying to get the ECU into Bootmode PLEASE HELP Post by: prj on May 04, 2015, 08:10:40 AM Sounds like you need a new ECU, as you shorted something out when messing around.
Title: Re: Big Troubles after trying to get the ECU into Bootmode PLEASE HELP Post by: R32VAG on May 05, 2015, 12:30:38 AM May i can install a new eprom chip?
Title: Re: Big Troubles after trying to get the ECU into Bootmode PLEASE HELP Post by: prj on May 05, 2015, 02:23:04 AM I don't see how a chip would affect the temperatures the way it does. You can try to flash it, but probably something is fried.
|