NefMoto

Hi peolpe!

i write the ecu file without checksum file in mmps.
after the reprogramation, i make a test and the engine starts. but in the second start, the engine dont works!
when i try to read the ecu in mpps appears "ecu not found"

the car is a passat v6 2004 BBG.

what i can be make now to solve this problem?

thanks!

How about checksumming the file before writing it?

Unplug the ecu for 5 minutes.

Plug it back in.

Do not attempt to start the car, or turn the key off.

Flash a file with good checksums.

Wouldn't MPPS correct checksums? According to AMT Cartech it should: "It offers like most other tools reading / writing operations and checksum support..."

How has that worked out so far? Is it genuine mpps?

I will try to make it!

I correct the checksum with the me7sum.exe and check with me7check.exe and found no erros!

In MPPS have the bottom for id ecu, read, write and checksum... i dont know whats the file i have to select when i click in checksum!

Not genuine!

Its a cracked version.

I read the original file and save on my HD

I edit on file the KRKTE because i install new injectors and save the new file without correct the checksum.

In MPPS, i click in WRITE and select this new file, when the work its complete, the problem inform to switchoff the key.

after it, i disconect the MPPS (EOBD2) and switchON and start the engine fine! switchoff.... when i try to start again the engine not work, the fuel pump not work... all not work!

and now... when i try to write i new file with the corrected checksum the MPPS dont found the ECU!

But i will try to make it, that the ddillenger say!

I think MPPS compares the file/checksums to another.

So... Click Checksum -> Select file you want to checksum -> Select/open ori file -> Save checksummed file -> Write checksummed file

Then you can write.

mpps has been perfect at checksumming for me

I bricked my ecu after a couple goes with mpps. it can fix them pretty easily, dont worry

I would check if it is not related to RSA checksum issue described already on Nefmoto forums...

I make it

unplug ecu for 5 minuts and plug back, i dont start the engine, the key is off.

but the problem still "ECU not found"

:(

The problema was solved!

I try again and make equal that the ddillenger say and MPPS writh the new file with the corrected checksum!

Thanks for helping!! ALL!

just boot it and will be fine

KRKTE is a 8 bits?

I install 320cc (FBY2850 18 holes) in V6 30v, how i can decrease in KRKTE?

I read a post here in Nefmoto, Tony say that not good decrease too much in KRKTE, how is this too much?

:)