|
Title: 8N0906018H fault help Post by: RallyeCAV606 on July 12, 2015, 02:00:58 PM hello to everyone. Nice and helpful group.
I have convert an AGU converted to BAM. I change all sensor turbo manifold injector and coils. This engine is in a '92 Corrado. The result is that I have some faults for the stuff is missing and this causing me a safe mode. I would like some help to remove this faults so the car can run as it should. These are the stuff missing and giving me the faults. ABS Airbag VVT because my actual engine is AGU without one EVAP Catalyst after catalyst O2 and recirculation valve (blowoff Valve) Anyone here can help me with this faults? Also I would like to know in what bytes I canfind the Esconf and how is coded in this ECU. Attached is my bin file. Thanks in advance. Title: Re: 8N0906018H fault help Post by: aef on July 12, 2015, 10:49:04 PM Hi,
start from here: http://s4wiki.com/wiki/Tuning#ESKONF and here: http://nefariousmotorsports.com/forum/index.php?topic=1457.0title= Its easy, just start and ask again. will help Title: Re: 8N0906018H fault help Post by: RallyeCAV606 on July 13, 2015, 03:05:19 PM Dear aef thanks for the help. I already read and learn a lot from s4wiki but I loose the solution in front of my eyes.
I'm not sure about the CW_CAN_R location.As I find from the winols project is at 101A*? I need to remove cluster abs and airbag too. Now what about checksum is the ME7Check Ok for that ECU? After check I will be write it back to ecu and I will be OK? Is there anything I have to do before upload Title: Re: 8N0906018H fault help Post by: aef on July 13, 2015, 10:02:49 PM Winols does your checksums. Tunerpro dont.
Me7sum will do the job too. check with me7check afterwards would recommend to do small steps. Do your ESKONF changes first and write the file. check your faults again. For Airbag and ABS is would try to use CLACAT but i am not sure. again: small steps allow you to understand what influences what Title: Re: 8N0906018H fault help Post by: RallyeCAV606 on July 17, 2015, 02:14:42 PM Thanks for everything.
I think I'm fine the only part I'm still looking is how I can modify the CAN. I need to remove this 3 faults and I'm done. 18057 - Powertrain Data Bus P1649 - 35-00 - Missing Message from ABS Controller 17931 - Crash Signal from Airbag Controller P1523 - 35-00 - Implausible Signal 18058 - Powertrain Data Bus P1650 - 35-00 - Missing Message from Instrument Cluster Title: Re: 8N0906018H fault help Post by: pedrosousa on August 15, 2015, 06:46:02 AM ESKONF 10BK4 7x1 MAP
Read the ESKONF topi to make the changes |