|
Title: Galletto boot mode issue Post by: scoot1043 on August 19, 2015, 12:37:42 PM Hi, Havent been on here for a while but recently got my self into a pickle.
Basicly I flashed a map onto my ecu a friend (who does it as a job) made. And flashed all good. Not problem. but then went to start it and it starts for a second and dies. To me after having this before says. Immobilizer issue. So got my Galletto out, (as have done a few times before to get it into boot mode and flash previous on but this time just comes up saying 'boot mode inactive'... Any one can shed some light on this would be grateful!! Title: Re: Galletto boot mode issue Post by: k0mpresd on August 19, 2015, 12:56:49 PM your friend (who does it as a job) gave you the wrong file to flash?
sounds more like stolen tune and youre cluelessly flashing files wondering why it doesnt work. good luck. Title: Re: Galletto boot mode issue Post by: scoot1043 on August 19, 2015, 01:06:07 PM your friend (who does it as a job) gave you the wrong file to flash? sounds more like stolen tune and youre cluelessly flashing files wondering why it doesnt work. good luck. Have done flashed my own files and edited then successfully before. Also all of his previous maps have been fine. If people are not going to try help then don't bother writing.... Title: Re: Galletto boot mode issue Post by: k0mpresd on August 19, 2015, 03:14:51 PM the "help" you want should have been helping yourself to some knowledge before you and youre "friend with a job" went about just randomly flashing the, what i can only assume is, the blatantly wrong file.
Title: Re: Galletto boot mode issue Post by: ddillenger on August 19, 2015, 03:36:12 PM It sounds like you flash an immo3 binary onto an immo2 ecu (Like using 032LP on 032DL). Post your ecu number, and the file number you flashed.
Title: Re: Galletto boot mode issue Post by: scoot1043 on August 23, 2015, 12:05:52 AM It sounds like you flash an immo3 binary onto an immo2 ecu (Like using 032LP on 032DL). Post your ecu number, and the file number you flashed. Hi, ok cool thanks! File is attached, and my ecu number is 06a 906 032 dr benzin me7.5 0003 Title: Re: Galletto boot mode issue Post by: scoot1043 on August 23, 2015, 12:28:02 AM Also has anyone used one of these? maybe i could deactive the immo via this?
Title: Re: Galletto boot mode issue Post by: ddillenger on August 23, 2015, 11:01:41 PM As I figured. Your ecu is immo2, this binary is 032MJ, immo3. You need to disable the immobilizer in the flash, or more likely just write an immo3 eeprom to the ecu, then flash.
I assume the VIN and EXTRA fields read XXXXXXXXXXXXXXXXXXXXXXXXXXXXXX with the new file? Title: Re: Galletto boot mode issue Post by: scoot1043 on September 02, 2015, 12:10:56 PM As I figured. Your ecu is immo2, this binary is 032MJ, immo3. You need to disable the immobilizer in the flash, or more likely just write an immo3 eeprom to the ecu, then flash. I assume the VIN and EXTRA fields read XXXXXXXXXXXXXXXXXXXXXXXXXXXXXX with the new file? Ok. Yes you are correct. |