|
Title: MPPS - ECU NO REPLEY Post by: b0ki on August 17, 2011, 06:06:48 AM I have MPPS clone version it always worked fine last days it would brick every ecu i work with it. It starts flashing and then i get MSG NO REPLAY FROM ECU. After that the car will not crank and i have to bench flash it with gallot. I notice when do slow mode flashing with mpps it works fine. Any idea ?
Title: Re: MPPS - ECU NO REPLEY Post by: Jason on August 17, 2011, 11:26:47 AM Have you recently changed software versions?
Title: Re: MPPS - ECU NO REPLEY Post by: b0ki on August 31, 2011, 05:24:00 AM Yes i did. any advice ?
Title: Re: MPPS - ECU NO REPLEY Post by: infinkc on September 01, 2011, 11:21:16 AM Yes i did. any advice ? what version to what version? some clones you cannot upgrade the software on or it will burn out the chip in the cable. Its a security that they put into having the original vs clone. Title: Re: MPPS - ECU NO REPLEY Post by: vwaudiguy on September 01, 2011, 04:31:35 PM What was the reason for changing software versions?
Title: Re: MPPS - ECU NO REPLEY Post by: chienliu1972 on October 18, 2011, 09:08:25 AM If you have updated to MPPS V5 firmware of hardware, you need a patch file of MPPS V5. Cause your MPPS V3 clone hardware would not be used in MPPS V5 again.
|