|
Title: No start after ECU read??Any ideas? Post by: nitrorocket on November 14, 2015, 09:29:35 PM Car is a 2003 Audi A6 2.7t. The ecu was read though obd with fuse 5 & 15 removed using Kess V2 to ensure there would be no interruption during the read. When read was complete ksuite asked "Do you want to run errors deletion". The options were ok or cancel, it then ran a little more, then said it was complete. I read two Porsches today with no issues at all.
Ran a scan with vcds. 18089 Control module Programming not finished P1681-35-00- Car will crank but not run, anyone heard of this? Why would it ask me to f up the ECU after a read?? Lol Thanks for any experience or advice. Title: Re: No start after ECU read??Any ideas? Post by: nitrorocket on November 14, 2015, 09:42:26 PM Car is a 2003 Audi A6 2.7T 6-speed.
HW: 0261208288 SW: 1037368391 VIN nr.: SW ver.: Spare: Engine: 2.7L V6/5VT HW Ver.: SW upg.: 4Z7907551S 0020 Title: Re: No start after ECU read??Any ideas? Post by: zillarob on November 14, 2015, 09:44:28 PM You see this yet?
http://nefariousmotorsports.com/forum/index.php?topic=981.0title= Title: Re: No start after ECU read??Any ideas? Post by: nyet on November 14, 2015, 09:46:08 PM that sticky needs a better topic
Title: Re: No start after ECU read??Any ideas? Post by: nitrorocket on November 14, 2015, 11:11:28 PM Tomorrow I will hook up my Kess v2 to the obd connection and see if it will let me flash the 4Z7907551R file. I hope that will work!
Title: Re: No start after ECU read??Any ideas? Post by: ddillenger on November 15, 2015, 10:27:45 AM Title: Re: No start after ECU read??Any ideas? Post by: nitrorocket on November 15, 2015, 04:40:07 PM I tried to flash in the 551s file with no luck, so I re read the ECU, used recovery mode with Kess Ksuite and it ran again!!
Thank you so much for advice! Title: Re: No start after ECU read??Any ideas? Post by: nyet on November 15, 2015, 06:11:24 PM I tried to flash in the 551s file with no luck I would not flash s back into that ecu. |