|
Title: Logging MAF sensor voltage Post by: vtraudt on December 12, 2015, 05:34:15 AM Could not find the MAF VOLTAGE value in the logging parameters of Me7.
Not available as a loggable parameter? Title: Re: Logging MAF sensor voltage Post by: Lost on December 12, 2015, 06:17:23 AM Sure it is
uhfm_w Title: Re: Logging MAF sensor voltage Post by: vtraudt on December 12, 2015, 07:06:12 AM Thanks much. Had used search term Massenstrom, but is listed as {HFM-Spannung}.
Title: Re: Logging MAF sensor voltage Post by: dream3R on December 14, 2015, 08:15:45 AM Sure it is uhfm_w Correct scaling is * 0.0048828125 Title: Re: Logging MAF sensor voltage Post by: vtraudt on December 14, 2015, 08:33:50 AM So by logging MAF values in g/sec and volt, I can verify if the MAF is properly scaled?
Title: Re: Logging MAF sensor voltage Post by: dream3R on December 14, 2015, 08:44:25 AM So by logging MAF values in g/sec and volt, I can verify if the MAF is properly scaled? No, you'll see the Volt vs map curve post any other corrections, scaling is another story. I use the Voltage to check for a bad maf normally e.g You could say at 4.5v 200 g/s in the map when the flow bench say's 185 g/s, this would not show up in the logs, but should show in your fuelling Title: Re: Logging MAF sensor voltage Post by: dream3R on December 14, 2015, 08:59:18 AM http://s4wiki.com/wiki/Mass_air_flow#Logging.2Ftuning.2Ftrouble_shooting
Needs an update but in General his explains it. |