|
Title: ME 3.8.3 fgtech galletto 4 Post by: fgtskofd on December 21, 2015, 11:08:33 AM hello
im looking at turning the IMMO off on a me3.8.3 iv only got tools kwp2000 and fgtech galletto 4. been doing lots of research and haven't found anything concrete for setting up this ecu in boot mode. i may have overlooked something on this topic, any help or guidance would be greatly appreciated. i have not worked with this ecu before thanks Title: Re: ME 3.8.3 fgtech galletto 4 Post by: k0mpresd on December 21, 2015, 11:12:55 AM you havent found anything about bootmode because there is no bootmode for them.
Title: Re: ME 3.8.3 fgtech galletto 4 Post by: fgtskofd on December 21, 2015, 11:25:33 AM ah i see thanks for the reply do i need to buy a EEPROM USB Programmer then ?
Title: Re: ME 3.8.3 fgtech galletto 4 Post by: fgtskofd on December 21, 2015, 12:06:40 PM or should i remove chip 24c04 and get a reader for it ?
thanks Title: Re: ME 3.8.3 fgtech galletto 4 Post by: k0mpresd on December 21, 2015, 04:28:44 PM desolder and use programmer.
Title: Re: ME 3.8.3 fgtech galletto 4 Post by: fgtskofd on December 21, 2015, 08:20:03 PM thanks found a topic for this finally
http://nefariousmotorsports.com/forum/index.php?topic=5622.0 Title: Re: ME 3.8.3 fgtech galletto 4 Post by: oxide32 on December 22, 2015, 11:29:59 AM or should i remove chip 24c04 and get a reader for it ? I have also tried using a test clip with this chip but it's very hit and miss if it will work. Just grab a hot air solder station. They aren't expensive and mines paid for itself time and againthanks Title: Re: ME 3.8.3 fgtech galletto 4 Post by: h100vw on December 22, 2015, 07:01:38 PM I get them off with a gas soldering iron and the hot air nozzle. A little lifting pressure off a scalpel blade and you can hear when the legs start to let go off the board.
Mark the board and chip obviously. ;) |