|
Title: my ECU part number, will Nefmoto be able to connect and work with it? Post by: Otrabajo on January 02, 2016, 08:57:18 AM folks,
my Audi A4B6 3.0L ASN engine is running the following ECU: VAG NUMBER: 8E0 909 559 Component: 3.0L V6/5V 0003 Soft coding: 0011501 ShopL Imp: 000 WSC 63351 i've been trying to connect with Nefmoto to the ECU by using a Ross Tech HEX-CAN cable with direct USB drivers, but no success. Nefmoto says it cannot echo / find the cable. But the cable is fully operational with VCDS software. Can you guys tell me Nefmoto is compatible with my ECU? if not, what are the alternatives for connecting to my ECU and doing flash read and writes? thank you in advance Otrabajo Title: Re: my ECU part number, will Nefmoto be able to connect and work with it? Post by: aef on January 02, 2016, 09:05:33 AM Put your cable into dumb mode in the vcds setting. this should make it work with nefmoto if your vcds is genuine cable.
google is your friend Title: Re: my ECU part number, will Nefmoto be able to connect and work with it? Post by: nyet on January 02, 2016, 10:18:18 AM Quote:
"You can also use (recent) VCDS (Ross-tech) cables with Nefmoto, but you may have to disable "intelligent mode" in the VCDS setup dialog" http://s4wiki.com/wiki/Tuning#Flashing_utilities Title: Re: my ECU part number, will Nefmoto be able to connect and work with it? Post by: Otrabajo on January 03, 2016, 01:19:05 PM sorry guys, i've been reading a lot before posting on this forum.
And yes, my Ross HEX-CAN cable "intelligent mode" is disabled before starting netmoto, but no way, i'm unable to connect to the ECU using Nefmoto although VCDS software works properly, for instance clearing all DTC errors. I'll give a try to Galleto software. thank you anyway. |