|
Title: what type of programmer do you use for immo chip Post by: volksdude on September 07, 2011, 09:44:37 AM got tired of all the possibilities so I want to know what you are using, maybe it'll help me narrowing the choice
Title: Re: what type of programmer do you use for immo chip Post by: infinkc on September 07, 2011, 10:41:37 AM got tired of all the possibilities so I want to know what you are using, maybe it'll help me narrowing the choice willem gq4x here www.mcumall.com i use a 8 pin clip with it, it has had issues before interfering with the other circuits on the ecu so i unsolder them most of the time and put them in a chip adapter. Batronix programmers are also a good choice, i have an older one that i used a lot but didnt work with win7. Better quality but more $, so you get what you pay for. The willem is a great option cause it will do the 800bb chips also with a fairly inexpensive adapter. Title: Re: what type of programmer do you use for immo chip Post by: volksdude on September 07, 2011, 11:28:20 AM willem gq4x here www.mcumall.com i use a 8 pin clip with it, it has had issues before interfering with the other circuits on the ecu so i unsolder them most of the time and put them in a chip adapter. Batronix programmers are also a good choice, i have an older one that i used a lot but didnt work with win7. Better quality but more $, so you get what you pay for. The willem is a great option cause it will do the 800bb chips also with a fairly inexpensive adapter. I was looking pretty hard on the willem as well, but maybe the cheapest one (with parrallel port) and especially if you say that the GQ4X has problem reading onboard Title: Re: what type of programmer do you use for immo chip Post by: Tony@NefMoto on September 07, 2011, 04:54:13 PM I have a Willem programmer I also bought from MCUMall. It will do 29F800 and 95040 chips as long as you buy the adapters.
Title: Re: what type of programmer do you use for immo chip Post by: chienliu1972 on September 25, 2011, 08:35:51 PM Is it Willem PCB50? Could this programmer read/write 95040 on ECU without desoldering it? I mean to use a 3M clip on 95040 to read/write by Willem PCB50.
|