NefMoto

Noob Zone => Noob Questions => Topic started by: ijik on February 16, 2016, 07:25:33 AM



Title: 1.8t AVJ
Post by: ijik on February 16, 2016, 07:25:33 AM
Hello, someone could help me find LAMFA map in my ecu file? I think address this map is 26BE2 but i'm not sure
Regards :)


Title: Re: 1.8t AVJ
Post by: adam- on February 16, 2016, 10:07:11 AM
I've got 1D216, axis at 1D1FA.


Title: Re: 1.8t AVJ
Post by: ijik on February 17, 2016, 02:39:38 AM
hymm you're right :) When i wos looking for this map suggesting a Community Project 1.8t Stage 1, there are some diffrent address than in my file. I am a beginner and I did not know that the same maps can be so far apart in similar files :o
So thank you very much for your help!! ;) Now I will seek further map such as LDRXN LDRXNZK KFZW/2 KFLDHBN
Regards


Title: Re: 1.8t AVJ
Post by: adam- on February 17, 2016, 02:57:04 AM
Have you even attempted?


Title: Re: 1.8t AVJ
Post by: ijik on February 17, 2016, 03:19:15 AM
No, it's my first steps with ECU. I am a student interested in electronics and automotive. Analyzed community projects (1.8t and 2.7t) and am in the process of learning Advisory: Understanding ECU Remapping: The Audi TT 1.8T Variants / Motronic ME7.x, this is interesting stuff but I can see that little I can. I learned the basics Winols and I'm trying to finding and understanding some maps. When I read the articles I see that the important thing are the logs, but I did not do them yet and do not know which blocks i need to login.  So many questions, so few answers :)


Title: Re: 1.8t AVJ
Post by: jimmcgee5 on February 17, 2016, 06:19:14 AM
here knock yourself out  :D


Title: Re: 1.8t AVJ
Post by: ijik on February 17, 2016, 08:20:45 AM
ol shittttt a lot of maps ;D thanks a lot bro :)
I think with a warm-up try to remove the rear 02 sensor, on Tuning-S4wiki is a lot about this, we'll see if I can make it :) The next step will be LAMFA modifications.
Regards!


Title: Re: 1.8t AVJ
Post by: ijik on February 18, 2016, 10:44:37 AM
I have a few questions...
1. My LAMFA map has strange x axis 85 87,5 90 92,5 95 97,5. I would like to be 50 60 70 80 90 and 97.5 like in community project. It is bad factory (i use 0,003052)? I don't know.
2. When i change something in my file and do checksum and is correct. Can i write this file to my ecu or i should check this file some other checksummer? I use Winols 2.24 end NefMoto VW Audi ME7 ECU Flasher 1.9.3.2?
Can anyone help?


Title: Re: 1.8t AVJ
Post by: ijik on March 09, 2016, 08:57:45 AM
Hello
I made some changes in my ecu. Changes concern LAMFA and LDRXN, I think engine load is too large. Can someone look at it and prompt what else i should do with this file? This can be used for daily driving?