|
Title: MSLUB Location Post by: Mythbuster74 on March 06, 2016, 12:51:11 PM I need to get my brothers car through emissions (018ch awm a4), so up until now I've just disabled the sai through the eskonf but I don't believe it'll pass this way. After looking around a little I think I've found it but I've never been very good/fully understood how to find maps and use the offsets and axis data.
I believe I've found it at 1AC2E and its an 8x1 16bit map. With values 6400 7936 9280 10752 13312 14592 15872 17024 without adding any axis data or units. Is this correct? I've attached a older version of 018ch file on it now Title: Re: MSLUB Location Post by: Mythbuster74 on March 08, 2016, 12:48:25 PM Hello... It's me.... I was wondering if after all this time you'd found... Lol
Can anyone help? Title: Re: MSLUB Location Post by: Mythbuster74 on March 09, 2016, 10:07:03 AM Nyet? DDillinger? Other forum God's?
Title: Re: MSLUB Location Post by: ddillenger on March 09, 2016, 10:57:46 AM 0x1AC2E is the start of the map.
Title: Re: MSLUB Location Post by: funnix on June 14, 2016, 01:39:34 AM Hey guys,
i am looking for MSLUB maplocation in 032DR_0002. Can anyone help? Title: Re: MSLUB Location Post by: Mythbuster74 on September 03, 2016, 09:15:58 AM 0x1AC2E is the start of the map. Could you also help me find MSLBAS? The single digit maps are always tricky. Zeroing MSLUB wasn't enough to set readiness or solve the no high idle issues. Title: Re: MSLUB Location Post by: Mythbuster74 on September 08, 2016, 02:54:04 PM (http://1.bp.blogspot.com/-fidVC-hy_gw/U7vRPXrDZoI/AAAAAAAACEo/GqebhQb7lSI/s1600/leeloo_BEARA.jpg)
Title: Re: MSLUB Location Post by: vwaudiguy on September 08, 2016, 03:44:44 PM Try 0x18381
Title: Re: MSLUB Location Post by: vdubnation on September 09, 2016, 07:39:18 PM hes right
Title: Re: MSLUB Location Post by: mister t on September 10, 2016, 01:17:01 PM Nyet? DDillinger? Other forum God's? [/quote I'll amend this post to state: "Nyet?, DDillinger (in shimmering Jedi robed guise a la Obi Wan), God....? Title: Re: MSLUB Location Post by: Mythbuster74 on September 13, 2016, 08:38:44 AM I've set the mslub map and the mslbas maps both to 0 for all values, but the car still doesn't idle up or set readiness. There's a resistor in the sai pump plug, and it's still turned on in the eskonf. Am I missing something?
Title: Re: MSLUB Location Post by: Mythbuster74 on September 13, 2016, 08:41:36 AM Looked at the wiki again and it said to unplug the pump, so I'll take out the resistor and report back.
|