|
Title: ME7.1.1 ECM and Flashing Equipment! Post by: CoupedUp on September 07, 2016, 04:10:33 PM I recently sold my last and only VAG car so I don't have a need for any of this stuff since I'm not an Electrical Engineer. All prices are OBO.
The ECU is a 4Z7907551R with a Stock BIN(I believe) only used it to start the car(2003 A6 2.7T) before this listing. It is missing all 4 screws on the back side but the adhesive is very much intact. Price: $100 shipped. (https://s21.postimg.org/p4m333efb/IMG_20160907_165439.jpg) All of below: Price: $95 shipped (https://s13.postimg.org/fltjb2tef/IMG_20160907_174715.jpg) The PSU has been modified with switch for easy start/kill and all 12V and ground rails trimmed and made accessible from the outside. Also, soldered to this is a setup for an ME7.1.1 bench flash(ECU pigtail, OBD-II connector, etc). I had planned on putting wire wrap on it after solidifying it was all correct but never got to it. Price: $25 Galletto Cable and Dumb Blue Cable - Price: $20 shipped (https://s13.postimg.org/ity0o4fo7/IMG_20160907_174719.jpg) USB PIC Programmer with 8-Pin Ponoma SOIC Clip - Price: $50 (https://s13.postimg.org/n5mmd4ml3/IMG_20160907_174728.jpg) Title: Re: ME7.1.1 ECM and Flashing Equipment! Post by: Ephry on September 22, 2016, 07:51:30 PM Any of this available still?
E I recently sold my last and only VAG car so I don't have a need for any of this stuff since I'm not an Electrical Engineer. All prices are OBO. The ECU is a 4Z7907551R with a Stock BIN(I believe) only used it to start the car(2003 A6 2.7T) before this listing. It is missing all 4 screws on the back side but the adhesive is very much intact. Price: $100 shipped. (https://s21.postimg.org/p4m333efb/IMG_20160907_165439.jpg) All of below: Price: $95 shipped (https://s13.postimg.org/fltjb2tef/IMG_20160907_174715.jpg) The PSU has been modified with switch for easy start/kill and all 12V and ground rails trimmed and made accessible from the outside. Also, soldered to this is a setup for an ME7.1.1 bench flash(ECU pigtail, OBD-II connector, etc). I had planned on putting wire wrap on it after solidifying it was all correct but never got to it. Price: $25 Galletto Cable and Dumb Blue Cable - Price: $20 shipped (https://s13.postimg.org/ity0o4fo7/IMG_20160907_174719.jpg) USB PIC Programmer with 8-Pin Ponoma SOIC Clip - Price: $50 (https://s13.postimg.org/n5mmd4ml3/IMG_20160907_174728.jpg) Title: Re: ME7.1.1 ECM and Flashing Equipment! Post by: Ephry on October 02, 2016, 09:19:45 AM Sent PM
Sent from my iPhone using Tapatalk Title: Re: Post by: Tricky0 on February 21, 2017, 05:49:28 AM Pm sent
Sent from my SM-G935U using Tapatalk Title: Re: Post by: vw4life on May 13, 2017, 03:24:54 AM Hello, could u/would u duplicate that set up?
I'll pay u up front, I have the galletto 1260 interface /cables. K line, lmk thank u. Sent from my SM-G900V using Tapatalk Title: Re: Post by: CoupedUp on May 21, 2017, 05:07:38 PM Hello, could u/would u duplicate that set up? I'll pay u up front, I have the galletto 1260 interface /cables. K line, lmk thank u. Sent from my SM-G900V using Tapatalk Are you just wanting the PSU with ME7.1.1 and OBD-II connectors? Also, it is much easier to reach me by email: seandeanc at gmail... |