NefMoto

Noob Zone => Noob Guides and FAQs => Topic started by: EuroXs4 on December 10, 2016, 12:53:56 PM



Title: errors??
Post by: EuroXs4 on December 10, 2016, 12:53:56 PM
Hey guys I am having the following problem.I am trying to read a me7.5 ecu with the nefmoto software.I keep getting this error:

Immobilizer not Authenticated and security access is required???Anyone know why???I can read the flash fine in boot mode.However in slow init mode i have this error.Anyone know why this is???Ecu has a stage 1 flash file from the me7.5 thread.Modified immobilizer flash to match the vehicle its installed in.Both the 95040 and the 29f800bb checksums have been corrected.


Starting loading of info.
Cancelling loading of info.
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have not been met.
Reasons preconditions failed:
-Starting loading of info.
Cancelling loading of info.
Disabling Windows sleep mode.
Reading ECU flash memory.
ECU reports programming session preconditions have not been met.
Reasons preconditions failed:
-Immobilizer not authenticated
Continuing despite programming session preconditions not being met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
ECU reports that security access is not allowed until required lockout time has elapsed.
Starting diagnostic session.
Start diagnostic session failed, ECU reports security access is required.
Reading ECU flash memory failed.
Continuing despite programming session preconditions not being met.
Negotiating communication timings.
Successfully changed to new communication timings.
Requesting security access.
ECU reports that security access is not allowed until required lockout time has elapsed.
Starting diagnostic session.
Start diagnostic session failed, ECU reports security access is required.
Reading ECU flash memory failed.


Title: Re:
Post by: macxxx on December 10, 2016, 11:57:21 PM
Immo is off?


Title: Re: errors??
Post by: EuroXs4 on December 17, 2016, 07:38:40 PM
Immo is on.On the Bench this is what I get...I tried different baud rates.No change.

Validated FTDI device is in dumb mode.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init failed.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init failed.
Disconnected
Connecting...
Starting slow init connection.
Connecting to address 0x01.
Slow init failed.
Disconnected


Title: Re:
Post by: macxxx on December 18, 2016, 04:47:00 AM
To read on bench you need to immo off but i see that you had the first errors while reading in car...


Title: Re: errors??
Post by: TijnCU on December 18, 2016, 09:56:02 AM
Does your bench harness give 12v on pin 121? I can bootmode flash without it, but not with nefmoto.


Title: Re: errors??
Post by: EuroXs4 on December 18, 2016, 11:36:58 AM
No I did not have pin 121 powered up.With galletto i can do it no problem without pin 121.With nefmoto no way in hell.So For nefmoto I need to power up pin 121??Ok I just set immo in 95040 to off and powered up pin 121.Still No change.I noticed the ecu is missing the ground pad from the pcb.looks to be lifted or missing.Could this be related to my issue??I thought the ground pads was just that??circled in this image whats missing.