|
Title: RS4 5120 hack problems Post by: armageddon on June 16, 2017, 02:12:00 PM I am helping a friend with his RS4, and doing the linearization runs we hit a problem
At 40% wgdc we change to 4bar sensor and 5120 hack I am helping a friend with his RS4, and doing the linearization runs we hit a problem At 40% wgdc we change to 4bar sensor and 5120 hack The throttle is being close and I can not figure out whats causing it He is runing 1.1bar wastegate actuatores I thought it was of being requesting too much too early causing an underboost, but after change that it´s still the same I suspect KFVPLGU is the problem, on 5120 hack I only divided the axis, does the table need to be divided also? attached 2 logs, one without throttle closing and one with the good one is only till 4000rpm cause the battary died don't mind the wrong scaling, he used the wrong .cfg Title: Re: RS4 5120 hack problems Post by: armageddon on June 17, 2017, 04:58:25 AM Just to add, I am using the same 5120 hack on mine S4 (with k-box file) without any issue
Title: Re: RS4 5120 hack problems Post by: armageddon on June 18, 2017, 05:07:30 AM any ideas for what is causing throttle cut?
Title: Re: RS4 5120 hack problems Post by: IamwhoIam on June 18, 2017, 02:24:21 PM do you see rlsol_w in your log or am I the only one seeing it?
Title: Re: RS4 5120 hack problems Post by: vdubnation on June 18, 2017, 02:41:54 PM do you see rlsol_w in your log or am I the only one seeing it? lol 113 @ 3psi its a messTitle: Re: RS4 5120 hack problems Post by: armageddon on June 19, 2017, 03:14:55 AM My mistake :P I though that I had lowered it, somehow I did not saved it
Will correct it later today. |