|
Title: EDC17C46 Immo off problem safe and start and stop Post by: romano21 on September 06, 2017, 04:41:57 AM Hello ALL
I have replace a dead Ecu on an Audi A4 2.0Tdi 143 EDC17C46 2.7 SW: 03L906018AC HW: 03L906018JL TC1767 it was replaced by the same version HW and SW I Make immo off in the flash manualy and in the eeprom Checksum ok. Car start but it does not work properly I have the SAFE light on the dashboard and the start function and stop dysfunction. i try many immo off in eproom but not work ! always Safe on dash I have just tested the method of Weboctopus same result for more information here is the error code I have in the 05 ACC / START 02241 - Motor control module; vehicle immobilizer not adapated in 01 Engine P1609 Crash shutdown on (I Think This one come from the base in the ecu donor) the car starts and rolls very well. but Safe to Dash You can help? Title: Re: EDC17C46 Immo off problem safe and start and stop Post by: mkxGTi on November 07, 2017, 05:24:42 PM post original flash|eeprom .bins. i'd like the immo off bins aswell. everybody claims they can do it themselves.
Title: Re: EDC17C46 Immo off problem safe and start and stop Post by: H2Deetoo on January 18, 2018, 02:02:19 AM Best solution is to transfer immo from original to donor ecu.
If that isn't possible then immo off in ecu is OK but better do it in eeprom and not in flash. And to remove the warning/error in cluster then you also need to disable the immo in the cluster. Title: Re: EDC17C46 Immo off problem safe and start and stop Post by: superglitch on January 18, 2018, 08:47:16 AM There’s no good working solution for this. Best option is to drive it to dealer, flash to stock and then have them do immo alignment (key adapt is what most call it), if they have issues because vin is different, unplug the ecu until it says to replace the broken ecu.
Title: Re: EDC17C46 Immo off problem safe and start and stop Post by: bennyboi on January 25, 2018, 09:13:32 AM post flash and eep!
|