|
Title: Disconnecting because no response was received for the Tester Present message?? Post by: EuroXs4 on September 13, 2017, 06:51:16 PM So I am trying to read this stock ecu on the bench.I am not having any luck with the nefmoto software tool.Any ideas what could be my issue??Ecu is powered up on bench 12vdc approx 2 amps.Immobilizer is disabled.I can connect using same cable to ecu using vcdsliter without issues.
Here is the log from the Nefmotor software: Validated FTDI device is in dumb mode. Disconnected Connecting... Starting slow init connection. Connecting to address 0x01. Slow init succeeded. Switching to KWP2000 session. Connected Disabling Windows sleep mode. Reading ECU flash memory. ECU reports programming session preconditions have been met. Negotiating communication timings. Successfully changed to new communication timings. Requesting security access. Security access granted. Starting diagnostic session. Disconnecting because no response was received for the Tester Present message. Disconnected Reading ECU flash memory failed. 100% complete. Restoring Windows sleep mode. Title: Re: Disconnecting because no response was received for the Tester Present message?? Post by: aef on September 13, 2017, 10:49:18 PM go to google:
Quote site:nefariousmotorsports.com Disconnecting because no response was received for the Tester Present message. http://nefariousmotorsports.com/forum/index.php?topic=6324.0 power up pin 121 Title: Re: Disconnecting because no response was received for the Tester Present message?? Post by: EuroXs4 on September 14, 2017, 03:40:24 PM Been there done that.Powered pin 121 up still no dice.Changed baudrate and it appears to be working.Just weird as I'm running win7 ultimate with all the right drivers and using a recommended cable.
|