NefMoto

Technical => Cluster and Immobilizer => Topic started by: adam- on October 23, 2017, 01:06:32 PM



Title: VWK501 Mapping Out
Post by: adam- on October 23, 2017, 01:06:32 PM
I wondering if anyone can help out here.

I've mapped out the VWK501 cluster software (ori. attached), as well as a .kp for it.  Some of them have question marks against it because I'm not sure.  I've also attached an Excel that I was given (I'm allowed to distribute it).

Does anyone else have anything else they can contribute towards it?  This is effectively following on from the needle sweep that Graeme has done.  I'd like to get the project loaded into IDA because I feel like that would be easier than an ECU.

If anyone has any comments, please contribute.


Title: Re: VWK501 Mapping Out
Post by: dilly on October 23, 2017, 05:37:36 PM
I wondering if anyone can help out here.

I've mapped out the VWK501 cluster software (ori. attached), as well as a .kp for it.  Some of them have question marks against it because I'm not sure.  I've also attached an Excel that I was given (I'm allowed to distribute it).

Does anyone else have anything else they can contribute towards it?  This is effectively following on from the needle sweep that Graeme has done.  I'd like to get the project loaded into IDA because I feel like that would be easier than an ECU.

If anyone has any comments, please contribute.

could you possibly locate the source of the program i made a post about earlier and see exactly what addresses it changes?
there is a shit ton of options to change and learning how the program does it would be cool...(somebody has to know what to do since they made the program)


Title: Re: VWK501 Mapping Out
Post by: adam- on October 23, 2017, 11:30:48 PM
It just knows the addresses to change and maps them accordingly. 


Title: Re: VWK501 Mapping Out
Post by: dilly on October 24, 2017, 09:08:44 AM
It just knows the addresses to change and maps them accordingly. 

Yeah so couldn't you see what addresses and values it changes and make a map pack for each software and just keep building off of that? Or am I just being dumb


Title: Re: VWK501 Mapping Out
Post by: dilly on October 24, 2017, 09:14:48 AM
Do you want my before and after cluster dumps so you can look at them?
I did lit needles and displays, cruise light mod, gauge sweep and brighter mfa display(which actually works)

Lmk I'll post them for you


Title: Re: VWK501 Mapping Out
Post by: adam- on October 24, 2017, 12:07:05 PM
I've made a map pack, that's what I'm saying.  I want to put more in it though.  I have all of those things that you covered.


Title: Re: VWK501 Mapping Out
Post by: dilly on October 24, 2017, 09:53:11 PM
I've made a map pack, that's what I'm saying.  I want to put more in it though.  I have all of those things that you covered.
ok ok gotchya