|
Title: about me7_95040 1.31 and 1.4 problem Post by: raffeale on January 14, 2020, 01:28:21 AM today I used me7_95040 to read ecu through obd interface but I got error messages, it is failed in initiating communication error =0x07
what's wrong? I change baudrate to 57600 and the result was same. the steps is turned on dashboard plugin kkl cable with ft 232rl chipset run me _95040 --ODB -p 3 -r test.bin I got error =0x07 I have installed the newest driver for kkl cable from from ftd website the port number is right ,I found it in windows device management. Title: Re: about me7_95040 1.31 and 1.4 problem Post by: raffeale on January 14, 2020, 01:38:13 AM today I used me7_95040 to read ecu through obd interface but I got error messages, it is failed in initiating communication error =0x07 what's wrong? I change baudrate to 57600 and the result was same. the steps is turned on dashboard plugin kkl cable with ft 232rl chipset run me _95040 --ODB -p 3 -r test.bin I got error =0x07 I have installed the newest driver for kkl cable from from ftd website the port number is right ,I found it in windows device management. Title: Re: about me7_95040 1.31 and 1.4 problem Post by: aef on January 14, 2020, 05:06:32 AM bootmode will work
there is a whole thread for this tool btw Title: Re: about me7_95040 1.31 and 1.4 problem Post by: dilly on January 14, 2020, 11:41:34 AM i get an error like yours when i run the program with no cable connected. perhaps your drivers are wrong. here is a gui version if you would like to try for shits and giggles. it has version 1.31 and 1.4 in it. just run me7gui. sometimes i had troubles with the command line so i just use gui whenever i can
Title: Re: about me7_95040 1.31 and 1.4 problem Post by: raffeale on January 14, 2020, 07:17:40 PM i get an error like yours when i run the program with no cable connected. perhaps your drivers are wrong. here is a gui version if you would like to try for shits and giggles. it has version 1.31 and 1.4 in it. just run me7gui. sometimes i had troubles with the command line so i just use gui whenever i can I have got an other error code when I use this tools without connection, I am pretty sure that my driver is ok, because the com port can be found in windows device management. when I.try to connected a port that don't exist , it will appear other error code. Title: Re: about me7_95040 1.31 and 1.4 problem Post by: raffeale on January 14, 2020, 07:18:45 PM bootmode will work there is a whole thread for this tool btw my ecu is 81 pins bosch me7,I dont know which pin is boot pin ? Title: Re: about me7_95040 1.31 and 1.4 problem Post by: aef on January 15, 2020, 02:14:40 AM use the board and the search to find out
everything is there, your lazy |