|
Title: Golf 4 cluster swap - ABS & ESP light via CAN? Post by: Trautec on February 28, 2020, 01:48:30 AM Hello Guys,
I swapped a 3B0 920 849 A full FIS Passat cluster into my Golf 4. I already got everything working except that the cluster is taking the signals from the plugs to control ABS and ESP lights instead of the CAN-Bus messages. Cluster, ECU and Brake have CAN connection - Only when I disconnect the CAN Bus from the cluster there are fault codes like "Missing CAN Bus message from XYZ" So for now, I have grounded pin 19 of the blue connector, so I dont have permanent flashing of ABS and brake warning in cluster Does anyone know which bit to change in this dump? I already know about 0x65 bit0 and bit1 controlling temerature and VSS via CAN/analog. I guess the setting for my Problem might be near this settings? Thanks in advance Title: Re: Golf 4 cluster swap - ABS & ESP light via CAN? Post by: Trautec on February 28, 2020, 01:51:07 AM Forgot the dump ::)
Title: Re: Golf 4 cluster swap - ABS & ESP light via CAN? Post by: cessnas on April 17, 2020, 11:22:06 AM You need to flash an Golf dump of the same ROM ID to your passat cluster
Title: Re: Golf 4 cluster swap - ABS & ESP light via CAN? Post by: johan99 on May 14, 2020, 09:06:19 PM I'd like to know if this has been solved. I have a 3B0 920 829B (Canadian passat tdi cluster) that I would like to put on a 2002 Jetta (bora). I had the same problem with abs and parking brake light, along with speedometer not working correctly. Cluster doesn't seem to accept any 1J0 or 1J5 dump... The difference with this cluster is that it has the total mileage and trip odometer positions flipped compared to all other vw clusters of this generation...
|