Title: ME7.5 95040 tool check please Post by: slimwadey on March 20, 2020, 03:24:50 PM Hi all
I have read, modified and written with the tools available. when i write i get the following message saying its written , but cannot verify. i dont have the car here to check it works . Would you say it was a success? Thanks for the help C:\Users\Steve>C:\Users\Steve\Desktop\new\me7_95040.exe --bootmode -w -p5 95040.bin Ver: 1.31 Com Port: 5 Baud Rate: 10400 Opening COM5 ... OK Starting Boot_mode ... uC identification response = 0xC5 (C167 derivatives) ... OK Sending Loader + MonitorCore ... MonitorCore successfully launched Initializing registers ... ... OK Sending EEPROM driver ... OK Searching Chip_Select pin ... P4.7 Configuring SPI Interface ... OK Checking EEPROM status ... 0x00F0 ... OK Writing EEPROM ................................ OK Verifying EEPROM write ... FAIL. (error=0x01) Closing COM5 Title: Re: ME7.5 95040 tool check please Post by: fknbrkn on March 21, 2020, 06:28:58 AM Read it and compare
Title: Re: ME7.5 95040 tool check please Post by: 1mouse3 on March 25, 2020, 04:03:03 PM do you all have all cluster fuses pull and posibly the radio as well to prevent the immo locking you out
Title: Re: ME7.5 95040 tool check please Post by: adam- on March 26, 2020, 01:42:23 AM It always fails for me too, but always works. I've done hundreds.
|