|
Title: P0140 Post by: totti on October 07, 2021, 11:18:27 AM Hi,
I've installed a 100cell cat and I could not insert the 2nd lamda sensor. I've disconnect it and switched off ESKONF. LSHHK to 11 CDKAT to 0 CDLASH to 0 But I've the error code sometimes after a long run. What to do? Thank you Title: Re: P0140 Post by: Blazius on October 07, 2021, 05:06:22 PM Code it out properly, s4wiki covers this, eskonf and those 3 are not enough.
Title: Re: P0140 Post by: totti on October 09, 2021, 02:23:46 AM Code it out properly, s4wiki covers this, eskonf and those 3 are not enough. that is written in s4wiki: If you intend to disconnect/remove the sensors, the first thing to try is to configure ESKONF (13 bytes starting at 0x10C75):[58]. As a side benefit, even if you still intend to leave the sensors installed and connected, you should not need to disable circuit diagnosis. The rear o2 sensor section a little bit confuse me. There are several subsections to switch it off. |