Title: MED17.5.2Launch Control Post by: yangbohan on November 30, 2022, 09:16:14 PM MED17.5.2 Can launch control be performed? I need it, but it cannot be started after changing with LC software. Please tell me the price! Thanks!
Title: Re: MED17.5.2Launch Control Post by: _nameless on December 01, 2022, 09:58:17 AM Odds are your tools are not doing a full write. Most likely only calibration. Take file with code and write it to the ecu and then read it back out. If it doesn't match bit for bit, then your tool is not doing a full write. If you are using ktaf that's your problem. Factory support says " don't modify outside calibration and you won't have a problem". So they are not going to fix it. Other tools will do full flash.
Title: Re: MED17.5.2Launch Control Post by: yangbohan on December 02, 2022, 12:39:39 AM Thanks! I use Dimsort for reading and writing and I see on the LC software official website that this ECU is not well supported
Title: Re: MED17.5.2Launch Control Post by: _nameless on December 02, 2022, 04:07:15 AM Thanks! I use Dimsort for reading and writing and I see on the LC software official website that this ECU is not well supported If it patched the file it will work as long as your tool writes the file back correctly. I suspect it is not. Do as I said above to testTitle: Re: MED17.5.2Launch Control Post by: yangbohan on December 05, 2022, 09:35:14 PM Thank you for your advice! I will try again
Title: Re: MED17.5.2Launch Control Post by: neuro on January 09, 2023, 02:51:12 PM launch control can be performed with launch17 software at www.neurosuite.ca (delete if not permitted).
|