|
Title: m5.9.2 engine won't start after flashing Post by: 00gtw00 on August 14, 2012, 12:42:54 AM ECU is M5.9.2 06A 906 018 GM ( 0 261 206 921 )
VW Golf 2.0 AQY After flashing engine won't start and vcds can't connect to ecu. MPPS see ecu and can flashing. I flashing ecu using ORI file but result is the same. I desolder flash and check content - is correct. I get ecu form car. On bench connected 1,3,43 pin to +12V, 2 pin to GND, 19 pin to k-line. Flashing process was finishing with no problems. Is some to do after flashing? Title: Re: m5.9.2 engine won't start after flashing Post by: @lq! on August 14, 2012, 02:02:21 AM i think you can need a new chip. it may be damaged.
Title: Re: m5.9.2 engine won't start after flashing Post by: pvl on August 14, 2012, 02:34:47 AM I think with the given solution i gave him, the ecu can be ressurected ;)
Different ending letters, but that doesn't matter for this ecu. Same hardware-design for same engine. Cheers, PvL |